Duplex pipe clamp manufacturer: what is the purpose of aluminum alloy pipe clamp?

Duplex pipe clamp manufacturer: what is the purpose of aluminum alloy pipe clamp?
Aluminum alloy pipe clamp valve, also known as aluminum alloy pipe clamp valve and aluminum alloy pipe clamp valve, is composed of left and right aluminum alloy valve bodies, rubber pipe jackets, large and small valve stems, upper and lower rams, guide posts and other components.
Wear resistance, anti-corrosion, anti freezing and good sealing performance. As long as the rubber sleeve is replaced, the valve body can be used all the time, and the service life is 4 ~ 6 times that of ordinary valves. The driving modes include manual, pneumatic, electric and other modes, and non-standard products can also be customized according to the needs of customers.
When the hand wheel is rotated clockwise, the large and small valve stems move the upper and lower gates at the same time, compress the pipe sleeve, close, and open after reversing. The gate completes the opening and closing of the valve up and down between the guide pillars. In addition, due to the bearing capacity of the rubber pipe sleeve, when switching, the operators feel an appropriate amount of resistance when rotating the hand wheel, and they have reached the pole of the switch. They shall not be assisted by more than one person as far as possible, and other tools are prohibited from switching.
Aluminum and gold pipe clamps are widely used in many industries. Many aluminum alloy pipe clamp installers operate nonstandard, and many problems occur in the later stage of installation. Yancheng Haili hydraulic parts small editor talks about the points that should be paid attention to in fixture installation, mainly including the following:
Before assembly on the welding plate, in order to better determine the direction of the clamp, it is recommended to mark the fixed place, then weld, insert the lower half of the clamp and place the fixed pipe. Add the other half of the pipe clamp and cover and tighten with screws. Do not directly weld the base plate for installing aluminum alloy pipe clamp.
When installing the guide rail, the guide rail can be welded on the foundation or fixed with screws, then push the guide rail nut into the guide rail, rotate 90 degrees, clamp the lower half pipe into the nut, place the pipe to be fixed, then place the upper half pipe clamp and cover plate, and fix with screws.
Aluminum alloy pipe clamp manufacturer
For overlapping assembly, the guide rail shall be welded on the foundation or fixed with screws. First install the lower half pipe to clamp, install the pipe to be fixed, and then install the upper half pipe to clamp and fix with screws to prevent loosening and cover rotation. Then install the two pipe clamps in the same way.
The above is the content introduced by the manufacturer of duplex pipe clamp. I hope it will be helpful to you.