How long is the service life of heavy pipe clamp!

How long is the service life of heavy pipe clamp!
What follows is the tentative imitation in China. At present, many large and small aluminum alloy pipe clamp manufacturers in China have launched pipe clamp valves, quickly occupied some markets with ultra-low prices, and brought some misunderstandings to users who have just come into contact with this valve, such as: the service life of pipe clamp valves is too short, the pipe sleeve usually breaks down in a few months, or even months, and their rubber technology is not enough to produce high wear-resistant Rubber pipe sleeve with high corrosion resistance and long service life. Even for ordinary imported pipe clamp valves, the average service life is much longer than that in China. Of course, users can choose according to the actual situation. After all, the relative price of imported valve products is high.
Pipe clamp installation procedure: before assembly on the welding plate, in order to better determine the direction of the clamp, it is recommended to mark the fixed position first, then weld, insert the lower half of the pipe clamp body, and place the pipe to be fixed. Then put on the other half of the pipe clamp body and the cover plate and tighten it with screws. Do not directly weld the bottom plate with pipe clamp installed.
1, plastic pipe clamp: every manufacturer is required to have a large injection molding machine, punching machine, CNC machine tool, forging machine equipment, the first plastic pipe clip is divided into plastic parts, upper and lower cover plate, screw nut, plastic body according to different types of customer needs to be molded out, the surface to lubricate, the selection of plastic particles tensile, hardness, anti-aging degree is necessary. The upper and lower cover plates are made by stamping machine, and then galvanized. The screws are made by CNC machine tool, then galvanized, and then the pipe clamps are combined and packaged by skilled workers.

2. Aluminum alloy pipe clamp: aluminum alloy pipe clamp is basically the same as plastic pipe clamp. The main pipe clamp body is made of aluminum alloy, so the selected equipment is mainly made of aluminum alloy injection machine.
3. U-shaped pipe clamp: the primary equipment is forging press and CNC machine tool equipment. Carbon steel shall be selected, baked in the oven to a certain extent, bent into U-shaped assembly with forging press, and then galvanized.
4. Flat steel pipe clamp: the method is the same as that of U-shaped pipe clamp.
Therefore, users can save a lot of installation time and cost, and improve the flexibility of using C-shaped guide rail. With this application, there is no need to consume a lot of time on rework of welding points. Another advantage is that there is a gap of about 1.5mm between the installed guide rail and the mounting seat, thus eliminating the risk of ponding.
Two versions of plastic pipe clamps can be effectively inserted into the open end of the guide rail. In addition to fixing a single guide rail, multiple guide rails can also be connected together.
As an economic component fixing method, welded stud has been applied in many industries, sometimes even a feasible solution. Since the entire surface of the copper plated stud is connected to the base, the connection is very firm. Due to the short welding time, the material deformation is small, the energy consumption is low, and the thermal stress is dispersed. It is also suitable for thin metal sheets and heat-resistant substrates.